Locating the dominant aeroacoustic source of a motorcycle helmet and its effect on rider-side noise
Journal of the Brazilian Society of Mechanical Sciences and Engineering, cilt.48, sa.14, 2026 (SCI-Expanded, Scopus)
- Yayın Türü: Makale / Tam Makale
- Cilt numarası: 48 Sayı: 14
- Basım Tarihi: 2026
- Doi Numarası: 10.1007/s40430-026-06989-0
- Dergi Adı: Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus, Aerospace Database, Compendex, INSPEC, Materials Science & Engineering Collection (ProQuest), Technology Collection (ProQuest)
- Anahtar Kelimeler: In-helmet noise, Microphone array, Motorcycle helmet, Noise source localization, On-road measurements, Wind tunnel
- İstanbul Üniversitesi-Cerrahpaşa Adresli: Evet
Özet
In-helmet noise is usually assessed through broadband attenuation, although the underlying aeroacoustic mechanisms are frequency-dependent and spatially non-uniform. This study localises the flow-induced sources on a motorcycle helmet and interprets them together with rider-side spectra measured on the road. A helmet mounted on a head-and-torso simulator was tested in an open-jet wind tunnel at four flow speeds, three streamwise positions and two visor states, and 240 source maps were generated in one-octave bands between 100 Hz and 5 kHz with a 64-channel phased array and CLEAN-SC deconvolution. The lower chin–neck region contained the map maximum in 208 of the 240 maps (86.7%), and in 90.8% of the maps over the frequency range in which the array resolves the helmet. Peak source level followed an effective velocity power law with exponent n between 6 and 7, consistent with surface-interaction dipole sources. Three helmets, one of them open-face, were then measured on a predefined route at 20 and 40 km/h: the exterior surface level exceeded the ear level by up to 13.5 dB at 40 km/h, while the ear and chin–neck channels of the reference helmet tracked each other more closely than either tracked the exterior. The identification is shown to be independent of the deconvolution step and of the definition of the analysis regions, and the measurement chain is verified by reproducing a known 15 cm helmet displacement to within one grid cell. The results identify the lower rim, the chin curtain and the sealing of the lower opening as the surfaces on which helmet noise-control effort should be concentrated.